A.radially from the shaft
B.parallel to each other and to the shaft
C.parallel to each other but at a right angle to the shaft
D.at an angle to each other and to the shaft
您可能感興趣的試卷
你可能感興趣的試題
A.3 or 5
B.5 or 7
C.7 or 9
D.9 or 11
A.sensible heat
B.latent heat
C.total heat
D.residual heat
A.centerline of the pump and the level of the liquid in the suction well when the source of liquid is below the pump
B.centerline of the pump and the suction liquid level when the source of liquid is above the pump
C.centerline of the pump and the level of the discharge liquid
D.liquid levels of the suction and discharge
A.total heat
B.residual heat
C.specific heat
D.superheat
A.Single stage or multistage
B.High pressure or low pressure
C.Open or close coupled
D.Horizontal or vertical
最新試題
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
The output volume of a positive fixed displacement pump can be changed only by （）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
If the head pressure of a reciprocating refrigeration compressor is excessive, （）.
A salinity indicator is used to determine the （）.
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.
One cause of high head pressure occurring in a refrigeration system can be （）.
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.
The temperature differential occurring between the inlet temperature of the fluid to be cooled and the outlet temperature of the cooling medium in a shell-and-tube heat exchanger is greatest in which of the flow designs listed?（）