A.dry bulb temperature
B.wet bulb temperature
C.saturation temperature
D.water vapor superheat
您可能感興趣的試卷
你可能感興趣的試題
A.The follow-up gear
B.The rudder angle indicator
C.The synchronous electric transmitter
D.A rudder angle limit switch
A.apparent slip
B.tree slip
C.pitch
D.propulsive efficiency
A.two or more impellers housed together in one casing and mounted on a single shaft
B.a single stepped impeller mounted in a progressively staged casing
C.a large radial clearance between the impeller and casing to prevent overheating due to
D.an increase in the discharge velocity of the liquid with a corresponding decrease in pressure through the stages
A.add refrigerant to the system
B.adjust the thermal expansion valve to the proper setting
C.adjust the float valve to the proper holding pressure
D.open the hand expansion valve
A.a stuck solenoid valve
B.a shortage of refrigerant
C.too much oil in circulation
D.too much superheat
最新試題
The major source of chemical contaminants in hydraulic fluid is （）.
A pressure drop through the refrigerant liquid line may cause （）.
A salinity indicator is used to determine the （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by （）.
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.
If the viscosity of the liquid being transferred remains constant as the discharge pressure increases, the rotary pump （）.
An excessive charge of refrigerant in an air-cooled refrigeration system can cause （）.
The usual symptoms of cavitation in a centrifugal pump is （）.