A.Carbon build up in the piston ring belt
B.Faulty operation of a cylinder un-loader
C.Compressor operation in an area of high relative humidity
D.Lifting of intercooler rebel valve
您可能感興趣的試卷
你可能感興趣的試題
A.system was overcharged with refrigerant
B.system was low on refrigerant
C.suction valves were leaking slightly
D.relief valve was leaking slightly
A.broken inlet valves
B.broken discharge valves
C.pulsations in the air distribution system
D.overloading of the air distribution system
A.warping head
B.fairlead
C.wildcat
D.capstan
A.system was overcharged with refrigerant
B.high pressure switch was improperly adjusted
C.expansion valve strainers were fouled
D.suction valves were leaking slightly
A.increased pump speed
B.excessive pump discharge pressure
C.too low of a tilting box angle
D.low pump speed
最新試題
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by （）.
An internal bypass is provided on some hydraulic system suction strainers to help reduce the possibility of （）.
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.
On tank vessels equipped with power operated cargo tank valves, the type of power operator most commonly used is （）.
The general purpose of a heat exchanger is to （）.
Thermostatic expansion valves can be adjusted for （）.
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.
The usual symptoms of cavitation in a centrifugal pump is （）.