A.check hydraulic oil levels every hour
B.check the rams for overheating
C.check for excessive oil leakage from rams
D.drain water from telemotor cylinders each watch
您可能感興趣的試卷
你可能感興趣的試題
A.prevent the gear box from leaking
B.prevent the oil from becoming inflammable
C.make sure it has not become contaminated
D.make sure the motor bearings are lubricated
A.slightly opened
B.throttled
C.fully opened
D.halfway opened
A.increase speed
B.increase the size of the cardent assembly
C.reduce wearing ring clearances
D.change the pump to a "close coupled" arrangement
A.Chemical energy
B.Mechanical energy
C.Thermal energy
D.Electrical energy
A.air bubbles in the sight glass
B.any leaks in the system
C.over-travel in the rudder angle indicator
D.lost motion in the rams
最新試題
The general purpose of a heat exchanger is to （）.
If the viscosity of the liquid being transferred remains constant as the discharge pressure increases, the rotary pump （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
The usual symptoms of cavitation in a centrifugal pump is （）.
One cause of high head pressure occurring in a refrigeration system can be （）.
Low compressor head pressure in a refrigeration system can be caused by（）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.