A.the four-way control valve failing to shift
B.the bleeder valve sticking in the open position
C.cold hydraulic fluid
D.a clogged air vent falter on the oil reservoir
您可能感興趣的試卷
你可能感興趣的試題
A.add fluid that is the same color as the fluid in the reservoir
B.add turbine oil because it is always a good substitute
C.add any oil that has the same viscosity as the hydraulic fluid
D.check the winch manufacturers instruction book
A.changing the angle of the tilting plate
B.changing the speed of the pump
C.moving the slide block and rotor
D.moving the shaft trunnion block
A.oil foaming in the compressor
B.higher than normal suction and discharge pressures with a higher box temperature
C.higher than normal discharge pressure with a normal box temperature
D.the compressor to run continuously
A.check hydraulic oil levels every hour
B.check the rams for overheating
C.check for excessive oil leakage from rams
D.drain water from telemotor cylinders each watch
A.prevent the gear box from leaking
B.prevent the oil from becoming inflammable
C.make sure it has not become contaminated
D.make sure the motor bearings are lubricated
最新試題
An excessive charge of refrigerant in an air-cooled refrigeration system can cause ().
One cause of high head pressure occurring in a refrigeration system can be ().
If the suction pressure at the refrigeration compressor is below normal, the cause can be().
A grease gun is generally used to lubricate a ().
Thermostatic expansion valves can be adjusted for ().
The control mode in which the final control element is moved from one of two flexed positions to the other is known as ().
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will ().
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by ().
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?()
The rate of heat transfer from a hot region to a cold region is affected most by the ().