A.Heat is given off from a high temperature region known as a heat sink
B.Heat transfer rate is affected most by the size of the heat sink involved
C.Heat transfer rate is affected most by the temperature difference between the heat source and the heat sink
D.Heat transfer by radiation will occur only by mass motion of a fluid substance
您可能感興趣的試卷
你可能感興趣的試題
A.Maritime Safety Administration
B.Master of the vessel
C.Chief Engineer
D.Chief Mate
A.size of the heat sink
B.temperature difference between the regions
C.size of the heat source
D.total heat of the system
A.the four-way control valve failing to shift
B.the bleeder valve sticking in the open position
C.cold hydraulic fluid
D.a clogged air vent falter on the oil reservoir
A.add fluid that is the same color as the fluid in the reservoir
B.add turbine oil because it is always a good substitute
C.add any oil that has the same viscosity as the hydraulic fluid
D.check the winch manufacturers instruction book
A.changing the angle of the tilting plate
B.changing the speed of the pump
C.moving the slide block and rotor
D.moving the shaft trunnion block
最新試題
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will ().
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by ().
Which of the listed pumps is NOT a positive displacement pump?()
An excessive charge of refrigerant in an air-cooled refrigeration system can cause ().
A salinity indicator is used to determine the ().
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by ().
An internal bypass is provided on some hydraulic system suction strainers to help reduce the possibility of ().
The general purpose of a heat exchanger is to ().
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?()
The usual symptoms of cavitation in a centrifugal pump is ().