A.Cross
B.Parallel
C.Counter
D.Circular
您可能感興趣的試卷
你可能感興趣的試題
A.remain constant along the tubes length
B.be greatest in a single pass counter flow heat exchanger
C.remain constant throughout the heat exchanger
D.vary from section to section through out the heat exchanger
A.a low load on the unit
B.a clogged pump suction strainer
C.a blockage in the line between the pump and hydraulic motor
D.the hydraulic motor turning too fast
A.cause of salt contamination
B.location of salt water contamination
C.chemical makeup of feed-water
D.level of alkalinity in condensate
A.refrigerant overcharge
B.overfeeding by the expansion valve
C.a restricted suction strainer
D.due to short cycling of the compressor
A.capacity will increase
B.capacity will decrease
C.suction pressure will increase
D.suction pressure will decrease
最新試題
A salinity indicator is used to determine the （）.
An excessive charge of refrigerant in an air-cooled refrigeration system can cause （）.
The general purpose of a heat exchanger is to （）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）
Which of the following statements is correct concerning heat transfer?（）
A salinity indicator is used to determine the （）.
The major source of chemical contaminants in hydraulic fluid is （）.