A.two position control
B.signal speed floating control
C.proportional control
D.reset control
您可能感興趣的試卷
你可能感興趣的試題
A.compressed air and nitrogen
B.helium and nitrogen
C.oxygen and hydrogen
D.oxygen and acetylene
A.moisture in the compressed air supply
B.excessive dryness in the compressed air supply
C.pressure surging in the compressed air receiver
D.insufficient lubrication of the system components
A.reset action
B.proportional action
C.two position action
D.rate action
A.command input
B.set point signal
C.output
D.feedback
A.set point
B.control point
C.deviation
D.offset
最新試題
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
Flame failure in an automatically fired auxiliary boiler can from a/an （）
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
The main purpose of port State control is not to（）
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）
（） is not installed on the main switchboar.