A.speed droop
B.compensation
C.idle speed setting
D.load limit control
您可能感興趣的試卷
你可能感興趣的試題
A.Large misalignments can be tolerated between the shaft and engine coupling
B.Slip is held to a minimum when reversing shaft rotation
C.Engine torsion vibrations to the driven shaft are eliminated
D.It aids in maintaining power factor
A.actuation
B.sensitivity
C.compensation
D.thrust shaft
A.advance as the load increases
B.retard as the load increase
C.remain unchanged regardless
D.always occur at top dead center
A.compensate for low oil level
B.increase governor promptness
C.prevent governor hunting
D.limit engine load
A.rack position should be adjusted
B.compensating needle valve should be opened fully compensating
C.needle valve should be adjusted to stabilize operation
D.speed limiting device should be adjusted
最新試題
The shipboard oil pollution emergency plan will be invalid after （）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
If separating effect is not good, which measure should be taken （）
The condensers located in various stages of a flash evaporator are cooled by（）
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?（）
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a（）
Using a file without a handle may result in （）
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）