A.the production of high pressure gases
B.the removal of expended combustion gases
C.the admission of air to the cylinder
D.all of the above
您可能感興趣的試卷
你可能感興趣的試題
A.Speed limiting governor
B.Over-speed governor
C.Over-speed trip
D.Over-speed relay
A.decreased viscosity
B.decreased pour point
C.increased flash point
D.increased viscosity
A.provide a reservoir for cylinder lubrication
B.pump oil into the combustion space for cylinder cooling
C.prevent excessive lubricating oil consumption
D.allow hydraulic oil film formation on the cylinder
A.produce the heat for ignition
B.decrease injection lag
C.increase ignition delay
D.aid in exhausting burnt gases
A.low sulfur content in the fuel
B.a loose injector inlet connection
C.late fuel injection
D.high injection pressure
最新試題
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
The main purpose of port State control is not to（）
Under MARPOL Code the ship to which it applies has to carry （）
The cetane rating of diesel fuel is an indication of the （）
（）are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
The shipboard oil pollution emergency plan will be invalid after （）
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）