A.vaporize, with the un-flashed water remaining at the temperature at which it entered the flash chamber
B.vaporize, with the un-flashed eater equalizing to the saturation conditions existing in the f lash chamber
C.vaporize, with the remaining water a t a temperature greater than it entered the flash chamber
D.boil, allowing steam bubbles to rise through the brine at the bottom of the flash chamber
您可能感興趣的試卷
你可能感興趣的試題
A.combined as part of the salt water feed heater
B.the open area above the brine levels in the first and second stages
C.combined as part of the distillate cooler
D.another term used to describe the vapor feed heater
A.distilling condenser
B.salt water feed heater
C.distillate cooler
D.flash chamber
A.higher than the first stage feed-water temperature and absolute shell pressure
B.lower than the first stage feed-water temperature and absolute shell pressure
C.the same as the first stage feed-water temperature and absolute shell pressure
D.not related to the feed-water temperature and absolute shell pressure
A.lowering brine discharge density
B.decreasing the absolute pressure of each stage
C.increasing the saltwater feed heater temperature
D.increasing the pressure at the spray pipe
A.Bedplate
B.Block
C.Base
D.Sump
最新試題
If separating effect is not good, which measure should be taken （）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the（）
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a（）
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）
Diesel engine air start system check valves are opened by （）
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）
Cold weather starting of a diesel engine may be made easier by（）
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）