A.deaerate the first effect distillate
B.filter the condensed flash vapors
C.deaerate the first and second effect distillate
D.remove small water droplets entrained in the flashed vapor
您可能感興趣的試卷
你可能感興趣的試題
A.vacuum drag from the auxiliary condensate system
B.individual vacuum pumps
C.a single non-condensing air ejector
D.a two stage air ejector
A.vaporize, with the un-flashed water remaining at the temperature at which it entered the flash chamber
B.vaporize, with the un-flashed eater equalizing to the saturation conditions existing in the f lash chamber
C.vaporize, with the remaining water a t a temperature greater than it entered the flash chamber
D.boil, allowing steam bubbles to rise through the brine at the bottom of the flash chamber
A.combined as part of the salt water feed heater
B.the open area above the brine levels in the first and second stages
C.combined as part of the distillate cooler
D.another term used to describe the vapor feed heater
A.distilling condenser
B.salt water feed heater
C.distillate cooler
D.flash chamber
A.higher than the first stage feed-water temperature and absolute shell pressure
B.lower than the first stage feed-water temperature and absolute shell pressure
C.the same as the first stage feed-water temperature and absolute shell pressure
D.not related to the feed-water temperature and absolute shell pressure
最新試題
The shipboard oil pollution emergency plan will be invalid after ()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
Which of the following items don’t belong to dock repair works?()
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
The main purpose of port State control is not to()
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to ()
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?()
()connectors hold best if a wire is accidentally pulled or a connection becomes loose.
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()