A.less piston slap and quieter running
B.increased crankshaft bearing wear
C.slightly greater piston wear
D.decreased side pressures
您可能感興趣的試卷
你可能感興趣的試題
A.Liner wear is distributed equally between the upper and lower portions of the cylinder
B.Excessive liner wear causes wear between piston ring and groove
C.Excessive, but uniform liner wear will not cause wear between piston ring and groove
D.Liner wear is normally greatest in the middle of the cylinder
A.alternation of side thrust
B.a breakdown of the lube oil film on the cylinder wall
C.worn piston boss piston pin bearings
D.fluctuating gas pressure in the combustion space
A.hard starting
B.excessive fuel consumption
C.loss of power
D.all of the above
A.provide added wear protection against today’s corrosive quality of fuel
B.increase overall valve strength due to the high gas pressures
C.assist in dissipating heat due to the extreme operating temperatures
D.reduce the overall weight of the valve thus helping eliminate valve spring surge and hammering
A.Excessive piston to liner clearance
B.The underside of the piston crown being excessively dirty lowering the rate of heat transfer
C.Faulty nozzle spray
D.All of the above
最新試題
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
Diesel engine air start system check valves are opened by （）
The main purpose of port State control is not to（）
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）
The shipboard oil pollution emergency plan will be invalid after （）
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
Flame failure in an automatically fired auxiliary boiler can from a/an （）
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）
The cetane rating of diesel fuel is an indication of the （）
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?（）