A.increased air pressure differenced before and aft air cooler
B.reduced exhaust temperature in all cylinders
C.reduced temperature difference between water inlet and outlet
D.both A and C
您可能感興趣的試卷
你可能感興趣的試題
A.exhaust and suction process
B.suction and compression process
C.combustion and exhaust process
D.working and exhaust process
A.compression stroke
B.suction stroke
C.expansion stroke
D.exhaust stroke
A.greater distillate purity through high temperature evaporation
B.cold shocking for scale removal is not required
C.less internal corrosion because of lower brine density
D.less feed-water is required for equal plant capacity
A.refrigerant bubbles in the lube oil
B.refrigerant reducing the lube oil viscosity
C.oxidation of the lube oil from overheating
D.reducing the floc or cloud point of the oil
A.Cooling the air to a temperature just above dew point
B.Heating the air to a point at which moisture will boil off ,then re-cooling it
C.Cooling the air to a point below dew point, then reheating it
D.Heating the air and then cooling it to a point below dew point
最新試題
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?()
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
Using a file without a handle may result in ()
Diesel engine air start system check valves are opened by ()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
() is not installed on the main switchboar.
Which of the following items don’t belong to dock repair works?()
The condensers located in various stages of a flash evaporator are cooled by()
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()
The main purpose of port State control is not to()