單項選擇題With No~1 and No~2 alternators running in parallel and the KW loads equally shared, one alternator is drawing much higher current than the other.What does this indicate?（）

A.The alternators are not generating the same voltages and should be adjusted on automatic voltage regulator rheostats
B.Alternator frequencies are different and should be adjusted on the governor speed controllers
C.Alternators are out of phase and should be tripped and paralleled again
D.One alternator has lost one of its phases


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題Operational amplifiers, used primarily in analog circuits, are characterized by（）

A.high input impedance, high gain and low output impedance
B.high input impedance, high gain and high output impedance
C.low input impedance, low gain and high output impedance
D.low input impedance, high gain and low output impedance

2.單項選擇題CFC refrigerants exposed to high temperature or direct flame, will decompose and may produce（）

A.methyl chloride
B.ammonia
C.hydrofluoric acid
D.ozone

3.單項選擇題The major difference between the discharge and suction valves installed in most low pressure, reciprocating air compressors is that（）

A.one valve seats upwards, while the other seats downwards
B.the reed valves used on the discharge are made substantially thicker and heavier than the suction valves
C.the suction valve springs exert a greater tension than the discharge valve springs
D.the discharge valve springs exert a greater tension than the suction valve springs

4.單項選擇題Which of the following problems will occur if the internal drain at either end of a hydraulic, two-way, spool-type directional control valve cylinder were to become plugged?（）

A.The reservoir would become vapor bound
B.The valve would be placed in hydraulic lock
C.The spring loaded relief ports would open
D.The buffering chambers would be unable to function

5.單項選擇題Hydraulically, servo-operated, automatic, change over valves, utilized in a two ram hydraulic steering gear, serve to（）

A.allow an alternate main pump to start in the fully loaded condition thus developing immediate full torque
B.prevent either main pump from being hydraulically motored when idle by cross pressure flow
C.prevent both units from operating simultaneously which could result in doubling the flow of oil and pressure leading to over pressurization of the system
D.all of the above