A.After stopping supplying sludge oil, the value and pipe should be flushed by flushed by diesel oil and the incinerator continue burning for 10 minutes
B.Close auxiliary burner firstly and then close main burner
C.After stopping fuel, restoring the position of main fuel supply valve
D.Stop blower as soon as stopping supplying fuel oil
您可能感興趣的試卷
你可能感興趣的試題
A.Scavenging time should be more 30 seconds before igniting
B.The temperature of sludge tank is 80~100℃
C.First igniting the incinerator with diesel oil, when the temperature of health is about 600℃, the sludge oil drawn in
D.The ash can be dumped into sea when the distance is more than 3 miles from land
When does auxiliary burner of incinerator put into operation? （）
Ⅰ.tart incinerator when it is cold
Ⅱ.he sludge for dealing with is little
Ⅲ.he sludge for dealing with is large
Ⅳ.he water and impurity in sludge are too much
Ⅴ.he temperature in incinerator is low
Ⅵ.ealing with little solid rubbish
A.Ⅰ+Ⅱ+Ⅲ+Ⅴ
B.Ⅰ+Ⅱ+Ⅲ+Ⅳ
C.Ⅰ+Ⅳ+Ⅴ+Ⅵ
D.Ⅰ+Ⅱ+Ⅲ+Ⅵ
A.filled with clean water before operation
B.keep air cushion in oil collecting space during running
C.check oil level during running
D.clean inner separator with low pressure stream
A.pay attention to operating parameters
B.renew and clean separating units in time
C.check oil level in separator to prevent overload
D.check separating effect, if it is bad, flush with large capacity water pump
A.overhauling every two year
B.working at intervals
C.renewing filtration material
D.pumping bilge water from different layers respectively
最新試題
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）
The main purpose of port State control is not to（）
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
Flame failure in an automatically fired auxiliary boiler can from a/an （）
Under MARPOL Code the ship to which it applies has to carry （）
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?（）