A.Configure a separate sub-interface for each PVC with a unique DLCI and subnet assigned to the sub-interface.
B.Configure each Frame Relay circuit as a point-to-point line to support multicast and broadcast traffic.
C.Configure many sub-interfaces on the same subnet.
D.Configure a single sub-interface to establish multiple PVC connections to multiple remote router interfaces.
您可能感興趣的試卷
你可能感興趣的試題
A.Allow users to develop their own approach to network security.
B.Physically secure network equipment from potential access by unauthorized individuals.
C.Encourage users to use personal information in their passwords to minimize the likelihood of passwords beingforgotten.
D.Delay deployment of software patches and updates until their effect on end-user equipment is well known and widely reported.
E.Minimize network overhead by deactivating automatic antivirus client updates.
A.It has the same maximum hop count as version 1.
B.It uses broadcasts for its routing updates.
C.It is a classless routing protocol.
D.It has a lower default administrative distance than RIP version 1.
E.It supports authentication.
F.It does not send the subnet mask in updates.
A.It establishes a static route to the 172.16.3.0 network.
B.It establishes a static route to the 192.168.2.0 network.
C.It configures the router to send any traffic for an unknown destination to the 172.16.3.0 network.
D.It configures the router to send any traffic for an unknown destination out the interface with the address 192.168.2.4.
E.It uses the default administrative distance.
F.It is a route that would be used last if other routes to the same destination exist.
A.It is locally significant.
B.It is globally significant.
C.It is needed to identify a unique instance of an OSPF database.
D.It is an optional parameter required only if multiple OSPF processes are running on the router.
E.All routers in the same OSPF area must have the same process ID if they are to exchange routing information.
A.10Mbps
B.11Mbps
C.54Mbps
D.100Mbps
最新試題
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?（）
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?（）
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?（）
Three access ports have been installed and configured to a small office.What term defines the wireless topology?（）
Which command encrypts all plaintext passwords?（）
Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
What is the purpose of the cisco Vlan Trunking protocol?（）