Refer to the exhibit. Which statement is true?()
A.The Fa0/11 role confirms that SwitchA is the root bridge for VLAN 20.
B.VLAN 20 is running the Per VLAN Spanning Tree Protocol.
C.The MAC address of the root bridge is 0017.596d.1580.
D.SwitchA is not the root bridge, because not all of the interface roles are designated.
您可能感興趣的試卷
你可能感興趣的試題
A.source MAC address
B.source IP address
C.source switch port
D.destination IP address
E.destination port address
F.destination MAC address
A.data link
B.network
C.physical
D.transport
A.RSTP significantly reduces topology reconverging time after a link failure.
B.RSTP expends the STP port roles by adding the alternate and backup roles.
C.RSTP port satates are blocking,discarding,learing,or forwarding.
D.RSTP also uses the STP proprsal-agreement sequence.
E.RSTP use the same timer-baseed process as STP on point-to-point links.
F.RSTP provides a faster transition to the forwarding state on point-to-point links than STP does.
Refer to the exhibit A frame on vlan 1 on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?()
A.trunk mode mismatches
B.vlans that do not correspond to a unique IP subnet
C.native vlan mismatches
D.allowing only vlan 2 on the destination.
Refer to the topology shown in the exhibit. Which ports will be STP designated ports if all the links are operating at the same bandwidth? ()
A.Switch A - Fa0/0
B.Switch A - Fa0/1
C.Switch B - Fa0/0
D.Switch B - Fa0/1
E.Switch C - Fa0/0
F.Switch C - Fa0/1
最新試題
A network administrator creates a layer 3 EtherChannel, bundling four interfaces into channel group 1. On what interface is the IP address configured?()
What are two enhancements that OSPFv3 supports over OSPFv2? ()
What is the default Syslog facility level?()
Which one of these is a valid HSRP Virtual Mac Address?()
Which is true about OSPF router-id?()
What command visualizes the general NetFlow data on the command line?()
What are three factors a network administrator must consider before implementing Netflow in the network?()
What OSPF command, when configured, will include all interfaces into area 0?()
What are three values that must be the same within a sequence of packets for Netflow to consider them a network flow?()
Refer to the exhibit.If the router Cisco returns the given output and has not had its router ID set manually, what value will OSPF use as its router ID?()