單項選擇題Cisco Catalyst switches CAT1 and CAT2 have a connection between them using ports FA0/13.An 802.1Q trunk is configured between the two switches.On CAT1,VLAN10 is chosen as native,but on CAT2 the native VLAN is not specified.What will happen in this scenario?()

A.802.1Q giants frames could saturate the link.
B.VLAN10 on CAT1 and VLAN1 on CAT2 will send untagged frames.
C.A native VLAN mismatch error message will appear.
D.VLAN10 on CAT1 and VLAN1 on CAT2 will send tagged frames.


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題Which command shows system hardware and software version information?()

A.show configuration
B.show environment
C.show inventory
D.show platform
E.show version

4.單項選擇題What must be configured on the network in order for users on the Internet to view web pages  located on Web Server 2?()

A.On router R2, configure a default static route to the 192.168.1.0 network.
B.On router R2, configure DNS to resolve the URL assigned to Web Server 2 to the  192.168.1.10 address.
C.On router R1, configure NAT to translate an address on the 209.165.100.0/24 network to  192.168.1.10.
D.On router R1, configure DHCP to assign a registered IP address on the 209.165.100.0/24  network to Web Server 2.

最新試題

At which layer of the OSI model dose PPP perform?()

題型:單項選擇題

What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?()

題型:單項選擇題

Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()

題型:單項選擇題

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()

題型:單項選擇題

Which pairing reflects a correct protocol-and-metric relationship?()

題型:單項選擇題

Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()

題型:單項選擇題

If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()

題型:單項選擇題

Which statement describes the rule of split horizon?()

題型:單項選擇題

Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?()

題型:單項選擇題

Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()

題型:單項選擇題