A. Switch1(config-if)# switchport port-security maximum 1
B. Switch1(config)# mac-address-table secure
C. Switch1(config)# access-list 10 permit ip host
D. Switch1(config-if)# switchport p ort-security violation shutdown
E. Switch1(config-if)# ip access-group 10
您可能感興趣的試卷
你可能感興趣的試題
A. addresses chosen by a company to communicate with the Internet
B. addresses that cannot be routed through the public Internet
C. addresses that can be routed through the public Internet
D. a scheme to conserve public addresses
E. addresses licensed to enterprises or ISPs by an Internet registry organization
A. A successor route is used by EIGRP to forward traffic to a destination.
B. Successor routes are saved in the topology table to be used if the primary route fails.
C. Successor routes are flagged as "active" in the routing table.
D. A successor route may be backed up by a feasible successor route.
E. Successor routes are stored in the neighbor table following the discovery process.
Which routing protocols can be used within the enterprise network shown in the diagram?（）
A.RIP v1
B.RIP v2
C.IGRP
D.OSPF
E.BGP
F.EIGRP
A. application layer
B. session layer
C. transport layer
D. network layer
E. datalink layer
F. physical layer
The internetwork infrastructure of company XYZ consists of a single OSPF area as shown in the graphic. There is concern that a lack of router resources is impeding internetwork performance. As part of examining the router resources, the OSPF DRs need to be known. All the router OSPF priorities are at the default and the router IDs are shown with each router. Which routers are likely to have been elected as DR?（）
A.Corp-1
B.Corp-2
C.Corp-3
D.Corp-4
E.Branch-1
F.Branch-2
最新試題
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）
At which layer of the OSI model dose PPP perform?（）
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?（）
What is the default administrative distance of OSPF?（）
Which statement is true, as relates to classful or classless routing?（）
How are VTP advertisements delivered to switches across the network?（）
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?（）
At which layer of the OSI model is RSTP used to prevent loops?（）
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?（）