A. It designates VLAN 999 for untagged traffic.
B. It blocks VLAN 999 traffic from passing on the trunk.
C. It creates a VLAN 999 interface.
D. It designates VLAN 999 as the default for all unkown tagged traffic.
您可能感興趣的試卷
你可能感興趣的試題
A. AH
B. MD5
C. PSK
D. ESP
A. ipv6 address PREFIX_1::1/64
B. ipv6 autoconfig 2001:db8:2222:7272::72/64
C. ipv6 autoconfig
D. ipv6 address 2001:db8:2222:7272::72/64
A. Broadcast frames are never sent to swiches.
B. Broadcast addresses use an incorrect format for the switching table.
C. A broadcast address will never be the source address of a frame.
D. Broadcasts only use network layer addressing.
E. A broadcast frame is never forwarded by a switch.
A. link bandwidth
B. hop count
C. link cost
D. administrative distance
E. link delay
A. The command is accepted and the respective VLAN is added to vlan dat.
B. The command is rejected.
C. The command is accepted and you must configure the VLAN manually.
D. The port turns amber.
最新試題
What is the purpose of the cisco Vlan Trunking protocol?（）
Which statement is true, as relates to classful or classless routing?（）
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?（）
Which command encrypts all plaintext passwords?（）
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
Which command displays the CHAP authentication process as it occurs between two routers?（）
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?（）
What is the default administrative distance of OSPF?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
Which IPsec security protocol should be used when confidentiality is required?（）