A. Enable VTP pruning
B. From privileged mode ,erase the startup configuration file,then reload.
C. From privileged mode ,erase the vlan date file, then reload.
D. Cycle the switch power.
您可能感興趣的試卷
你可能感興趣的試題
A. FE08::280e:611:a:f14f:3d69
B. FE81::280f:512b:e14f:3d69
C. FE80::380e:611a:e14f:3d69
D. FEFE:0345:5f1b::e14d:3d69
A. 4094
B. 1024
C. 8190
D. 2046
E. 4096
A. RIPng
B. OSPFv3
C. static
D. IS-IS for IPv6
A. 16
B. 2
C. unlimited
D. 4
A. a primary route,stored in the routing table
B. a backup route,stored in the routing table
C. a backup route,stored in the topology table
D. a primary route,stored in the topology table
最新試題
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?（）
What is the subnetwork address for a host with the IP address 201.100.5.68/28?（）
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?（）
Which statement describes the rule of split horizon?（）
Which IPsec security protocol should be used when confidentiality is required?（）
Three access ports have been installed and configured to a small office.What term defines the wireless topology?（）
Which pairing reflects a correct protocol-and-metric relationship?（）
What is the purpose of the cisco Vlan Trunking protocol?（）
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?（）
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?（）