A. >
B. #
C. ?
D. *
E. All of the above
F. None of the above
您可能感興趣的試卷
你可能感興趣的試題
A. Defines the network topology
B. Access to network resources
C. Routing and switching functions
D. Content Filtering
E. Intrusion Detection
A. show boot
B. show flash
C. show register
D. show version
E. show config
You are the administrator of the Testking network and you have forgotten the password to one of your routers. After completing the password recovery procedure the router returned to its normal operation. The config-register was set back to the initial default value.
What is this value?（）
A. 0x2112
B. 0x2104
C. 0x2102
D. 0x2142
E. 0x2100
A new switch is installed in the Testking network. This switch is to be configured sothat VLAN information will be automatically distributed to all the other Cisco Catalyst switches in the network.
Which of the conditions below have to be met in order for this to occur?（）
A. The switch that will share the VLAN information must be in the VTP Server mode.
B. The switches must be in the same VTP domain.
C. The switch that will share the VLAN information must be configured as the root bridge.
D. The switches must be configured to use the same VTP version.
E. The switches must be configured to use the same STP version.
F. The switches must be configured to use the same type of ID tagging.
G. The switches must be connected over VLAN trunks.
A. 802.1q forwarding
B. VTP transparent mode
C. Cut-through
D. Store-and-forward
E. Fragment-free
F. Frame-filtering
最新試題
Given a subnet mask of 255.255.255.224, which of the following addresses can be assigned to network hosts?（）
What is the purpose of typing o/r 0x2142 during a password recover procedure on a 2500 series router?（）
Which statement describes the rule of split horizon?（）
A network host is configured as follows: Host IP address: 192.168.16.183 Subnet mask: 255.255.255.224 Default gateway: 192.168.16.190 Which of the following statements describe the network to which this host is attached?（）
Which characteristics are representative of a link-state routing protocol?（）
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational? （）
Which of the following options lists the steps in PPP session establishment in the correct order?（）
You are configuring a new Catalyst switch that you want to manage remotely from workstations on other network segments within your enterprise.Which of the following are required to allow remote management of the switch over IP?（）
Which of the following correctly describe steps in the OSI data encapsulation process?（）
New switches have been purchased for a network upgrade. The objective for the network design emphasizes efficient, error-free transport instead of fast transport.Which switching mode should be configured on the new switches to provide error-free transport to the network? （）