A. Router# show version
B. Router# show flash
C. Router# show memory
D. Router# show buffers
E. Router# show running-config
F. All of the above
您可能感興趣的試卷
你可能感興趣的試題
After logging into the RtrB router, you issue the "show interface" command as displayed below:
After considering the effects of the command output illustrated in the exhibit above,which of the following protocols are operational on the serial link?（）
A. PPP
B. IP
C. Compression
D. IPX
E. Multilink
F. ATX
A. Distribution channel failures
B. Feature capabilities
C. Memory capacity needs
D. Hardware product platform
E. Programming language requirements
F. Run location and compression status
A. The memory capacity requirements
B. The hardware product platform
C. The distribution channel
D. The feature capabilities
E. The run location and compression status
A. Router# copy tftp flash
B. Router# copy flash run
C. Router(config)# restore flash
D. Router(config)# repair flash
E. Router#copy flash tftp
F. Router# copy start flash
After making changes to the router, you issue the "copy running-config startup-config" command to save changes. After reloading the router, the router comes up in setup mode. You again make changes, save them, and reboot. Again,the router comes up in setup mode.
What is the most likely cause of this?（）
A. The NVRAM is corrupted.
B. The boot system commands were omitted in the configuration.
C. The configuration register setting is incorrect.
D. The upgraded configuration incompatible with the hardware platform.
E. The upgraded IOS incompatible with the hardware.
最新試題
Which of the following contribute to congestion on an Ethernet network?（）
Which connections allow the use of full-duplex Ethernet?（）
Which command is used to display the placement and direction of an IP access control list on a router?（）
Which of the following statements regarding routed and routing protocols are true?（）
A network host is configured as follows: Host IP address: 192.168.16.183 Subnet mask: 255.255.255.224 Default gateway: 192.168.16.190 Which of the following statements describe the network to which this host is attached?（）
Which of the following describe router functions?（）
The network 172.12.0.0 needs to be divided into subnets where each subnet has the capacity of 458 IP addresses.What would be the correct subnet mask to accomplish this division keeping the number of subnets at the maximum? （）
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?（）
What does a configuration Register Setting of 0x2105 indicate to the Router? （）
Which characteristics are representative of a link-state routing protocol?（）