A. Full-duplex Ethernet uses CSMA/CD to prevent collisions.
B. Half-duplex Ethernet uses a loopback circuit to detect collisions.
C. A full-duplex Ethernet card allows 20Mbps for data transmission.
D. Full-duplex Ethernet makes use of two pairs of wires for data.
E. An Ethernet hub can operate both half and full duplex simultaneously.
您可能感興趣的試卷
你可能感興趣的試題
A. The destination host sends a request to the source for retransmission.
B. The jam signal indicates that the collision has been cleared.
C. The hosts will attempt to resume transmission after a time delay has expired.
D. An electrical pulse indicates that the collision has cleared.
E. The router on the segment will signal that the collision has cleared.
F. The hosts will do nothing, as the higher layers are responsible for data error correction and re-transmission.
A. 802.11
B. 802.5
C. 802.3ab
D. 802.3ae
E. 802.3z
F. 802.3u
A. Too many hosts in a broadcast domain
B. Full duplex operation
C. Broadcast storms
D. Multicasting
E. Segmentation
F. Low bandwidth
A. The use of Full-Duplex Mode.
B. The Creation on New Collision Domains.
C. The Creation on New Broadcast Domains.
D. The Addition of Hubs to the Network.
E. The use of switches in the Network.
F. The Amount of ARP or IPX SAP Traffic.
A. Increasing the number of collision domains.
B. Micro-segmenting the network.
C. Adding hubs for connectivity to the network.
D. Putting additional switches in the network.
E. Implementing VLANs in the network.
最新試題
A Class C network address has been subnetted with a /27 mask.Which of the following addresses is a broadcast address for one of the resulting subnets?（）
Which of the following options lists the steps in PPP session establishment in the correct order?（）
Identify three valid host addresses in the 192.168.27.0 network with a subnet mask of 255.255.255.240. （）
Which of the following if addresses can be assigned to host devices?（）
Which characteristics are representative of a link-state routing protocol?（）
Which statement describes the rule of split horizon?（）
New switches have been purchased for a network upgrade. The objective for the network design emphasizes efficient, error-free transport instead of fast transport.Which switching mode should be configured on the new switches to provide error-free transport to the network? （）
Which command is used to display the placement and direction of an IP access control list on a router?（）
Which connections allow the use of full-duplex Ethernet?（）
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?（）