A. The frame is dropped.
B. The frame is addressed with a broadcast MAC address and sent out all ports.
C. The frame is sent out all ports except the receiving port.
D. An ARP request is sent out all ports except the receiving port.
E. A destination unreachable message is sent back to the source address.
F. None of the above.
您可能感興趣的試卷
你可能感興趣的試題
A. A device waits for an electronic signal before transmitting.
B. A device listens and waits until the media is not busy before transmitting.
C. All devices on an Ethernet segment see data that passes on the network medium.
D. Only the sender and the receiver devices see data that passes on the network medium.
E. Ethernet networks allow you to configured devises with higher transmission priority.
A. Hosts use a logical ring topology.
B. Hosts use a logical bus topology
C. Hosts must wait for an electronic signal to transfer data.
D. Hosts are directly connected to a wiring concentrator called a MSAU.
A. Each device on the Ethernet segment stops transmitting for a short time.
B. A jam signal informs all devices that a collision occurred.
C. When data transmission resumes, the devices that were involved in the collision have priority to transmit.
D. The devices that are involved in the collision stops transmitting for a short time.
E. The collision invokes a random back-off algorithm.
A.172.31.128.255./18
B.255.255.255.255
C.192.168.24.59/30
D.224.0.0.5
E.All of the above
A. Gateway DP
B. Reverse ARP
C. proxy ARP
D. Inverse ARP
E. indirect ARP
最新試題
TestKing.com has allocated the IP add 199.144.27.0 is its network, to provide flexibility for the LAN design, a subnet mask of 255.255.255.240 has been chosen. Which of the following address can be assigned to LAN on the resulting subnets.（）
Which of the following describe router functions?（）
What is the purpose of typing o/r 0x2142 during a password recover procedure on a 2500 series router?（）
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational? （）
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? （）
What is the purpose of pressing the Ctrl+Break keys during the router password recover procedure?（）
A router with a serial interface will be used for an ISDN link.What other function group devices are required to complete the connection to the service provider? （）
A Router with a BRI/T interface will be used for an ISDN Connection what other ISDN device is required to complete this connection? （）
Which characteristics are representative of a link-state routing protocol?（）
What should the configuration register value be after successfully completing the password recover procedure and returning the router to normal operation? （）