A.excessive loads are placed on the winch
B.minimum pull is being exerted by the winch
C.automatic operation of the winch is desired
D.wire is being retrieved at the maximum rate
您可能感興趣的試卷
你可能感興趣的試題
A.less internal corrosion because of lower brine density
B.higher temperature evaporation for lower salinity of the distillate produced
C.less scale formation in a flash evaporator
D.less feed-water required for a flash evaporator
A.clarifier
B.oil/water separator
C.incinerator
D.distiller
A.booster pump
B.evaporator
C.incinerator
D.cooler
A.wax precipitation in the lube oil
B.contamination by dust, scale, or moisture
C.refrigerant bubbles in the lube oil
D.refrigerant reducing the lube oil viscosity
A.increasing refrigerant pressure in the coil
B.increasing chilled water flow through the cooler
C.sub-cooling the refrigerant in the condenser
D.superheating the refrigerant in the compressor
最新試題
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()
The shipboard oil pollution emergency plan will be invalid after ()
()are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
If separating effect is not good, which measure should be taken ()
The main purpose of port State control is not to()
The treatment of the fuel oils involves storage, heating, filtering and()
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a()