A.maintain even distribution of bearing wear
B.maintain a constant oil temperature
C.maintain a pressurized film between moving surfaces
D.remove entrained water
您可能感興趣的試卷
你可能感興趣的試題
A.so as to never be integral lube
B.with a sloped bottom
C.only of nonferrous, noncorrosive metals
D.with drain/return lines terminating just above or at the designed normal level
A.is an indication of the amount of noncombustible material present in the oil
B.indicates the quantity of energy released by burning a unit amount of the fuel
C.is useful for determining proper atomization temperatures
D.reflects the overall thermal efficiency of the fuel oil service system
A.point of opening
B.speed of opening
C.lift from its seat
D.all of the above
A.Steel brush
B.Fine emery cloth or steel wool
C.A section of the removed compression ring
D.A case hardened scraper
A.improper adjustments
B.contaminated fuel
C.coated fuel lines
D.excessive vibration
最新試題
The ISPS Code consists of a mandatory section-Part A, which shows（）
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the（）
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?（）
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）
The main purpose of port State control is not to（）
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?（）
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）