A.TE1
B.TE2
C.NT1
D.NT2
您可能感興趣的試卷
你可能感興趣的試題
A. 199.141.27.33
B. 199.141.27.112
C. 199.141.27.119
D. 199.141.27.126
E. 199.141.27.175
F. 199.141.27.208
A. The switch name must match the workgroup name of the local network.
B. The switch must be configured with an IP address and default gateway.
C. The remote workstations must have access to the management VLAN of the switch.
D. CDP must be enabled on the switch so that it can be located by other devices on the network.
A. show access-list
B. show ip route
C. show ip interface
D. show interface
E. show interface list
F. show ip interface brief
A. To restart the router.
B. To bypass the configuration in NVRAM.
C. To view the lost password.
D. To save the changes to the configuration.
E. To enter ROM Monitor mode.
A. cut-through
B. fragment-free
C. frame-filtering
D. store-and-forward
E. 802.1q forwarding
F. VTP transparent mode
最新試題
Which statement describes the rule of split horizon?()
Which Frame Relay feature is responsible for transmitting keepalives to ensure that the PVC does not shut down because of inactivity?()
Which connections allow the use of full-duplex Ethernet?()
A Router with a BRI/T interface will be used for an ISDN Connection what other ISDN device is required to complete this connection? ()
The network 172.12.0.0 needs to be divided into subnets where each subnet has the capacity of 458 IP addresses.What would be the correct subnet mask to accomplish this division keeping the number of subnets at the maximum? ()
What feature of a networks switch allows an administrative to create separate broadcast domains?()
Given a subnet mask of 255.255.255.224, which of the following addresses can be assigned to network hosts?()
Which of the following correctly describe steps in the OSI data encapsulation process?()
What does a configuration Register Setting of 0x2105 indicate to the Router? ()
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?()