A.damage to the un-loader operating diaphragm
B.an increase in current flow to the motor
C.high pressure in the receiver and filter
D.an excessive consumption of crankcase oil
您可能感興趣的試卷
你可能感興趣的試題
A.first stage
B.second stage
C.distillate cooler
D.salt water feed heater
A.Gravity siphon effect
B.Higher vacuum in the second-stage
C.Difference in brine density between first and second stages
D.lower pressure in first-stage
A.decreased compression ratio
B.higher than normal power consumption
C.un-loader malfunction
D.water in the lubricating oil
A.reduce friction between moving surfaces
B.provide even distribution of bearing wear
C.reduce the accumulation of harmful detergents
D.maintain a constant oil temperature output at each beating
A.vapor feed heater
B.air ejector condenser
C.saltwater heater
D.distillate cooler
最新試題
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
The temperature differential occurring between the inlet temperature of the fluid to be cooled and the outlet temperature of the cooling medium in a shell-and-tube heat exchanger is greatest in which of the flow designs listed?（）
The general purpose of a heat exchanger is to （）.
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by （）.
When the steering gear is in operation, you should （）.
If the viscosity of the liquid being transferred remains constant as the discharge pressure increases, the rotary pump （）.
The major source of chemical contaminants in hydraulic fluid is （）.
A salinity indicator is used to determine the （）.
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.