A.vaporizes in the condenser
B.reaches the compressor through the suction line
C.flashes in the liquid line
D.condenses in the receiver
您可能感興趣的試卷
你可能感興趣的試題
A.heat
B.power
C.horsepower
D.foot-pound
A.worn bearings and piston pins
B.slugging due to flooding back
C.too much oil in circulation
D.All of the above
A.superheated
B.super-cooled
C.at or below the dew point
D.All of the above
A.open the steam line mot valve
B.drain the steam cylinder
C.close the steam cylinder drains
D.open the liquid cylinder drains
A.rudder will respond sluggishly
B.hydraulic rams will over-speed
C.sight glass will show bubbles
D.ram relief valves will lift
最新試題
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.
Thermostatic expansion valves can be adjusted for （）.
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by （）.
The temperature differential occurring between the inlet temperature of the fluid to be cooled and the outlet temperature of the cooling medium in a shell-and-tube heat exchanger is greatest in which of the flow designs listed?（）
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
The output volume of a positive fixed displacement pump can be changed only by （）.
The usual symptoms of cavitation in a centrifugal pump is （）.