A.slightly opened
B.throttled
C.fully opened
D.halfway opened
您可能感興趣的試卷
你可能感興趣的試題
A.increase speed
B.increase the size of the cardent assembly
C.reduce wearing ring clearances
D.change the pump to a "close coupled" arrangement
A.Chemical energy
B.Mechanical energy
C.Thermal energy
D.Electrical energy
A.air bubbles in the sight glass
B.any leaks in the system
C.over-travel in the rudder angle indicator
D.lost motion in the rams
A.The pump delivers full capacity when started, but gradually slackens off toan abnormally low flow
B.The pump packing gland overheats after short operating periods
C.The motor over-current protective device continually shuts the pump down
D.Pounding noises can be heard at the pump suction chest
A.diameter of the discharge piping, with all other factors remaining the same
B.diameter of the suction piping, with all other factors remaining the same
C.width of the impeller only
D.diameter of the impeller
最新試題
If the head pressure of a reciprocating refrigeration compressor is excessive, ().
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should ().
When the steering gear is in operation, you should ().
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by ().
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by ().
A grease gun is generally used to lubricate a ().
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?()
The rate of heat transfer from a hot region to a cold region is affected most by the ().
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by ().
The general purpose of a heat exchanger is to ().