A.They conduct heat poorly
B.They are expensive
C.They cannot be replaced
D.They require special tools for removal
您可能感興趣的試卷
你可能感興趣的試題
A.The diesel oil must never be allowed to mix with the heavy fuel
B.The temperature of the fuel from the pre–heater should be gradually reduced after switching over the three–way valve
C.The heating steam to the pre-heater should be secured as soon as the diesel fuel passes through the three-way valve
D.The heating steam must be secured before the diesel oil passes through the three-way valve
A.To prevent internal damage form local overheating
B.To ensure the fuel nozzles are flushed clean
C.To clear the smoke stack
D.To let the waste heat boiler reduce its rate of steam generation
A.loss of power
B.misfiring
C.low fuel oil pressure
D.All of the above
A.Increase the cooling water flow to the engine
B.Secure or reduce fuel to that cylinder
C.Screw down on the pressure adjusting spring to decrease to decrease popping pressure
D.Readjust the injection timing
A.The greater the atomization, the greater the penetration
B.The greater the atomization, the less the penetration
C.The degree of atomization has nothing to do with the degree of penetration
D.Atomization and penetration are one and the same
最新試題
Which of the following items don’t belong to dock repair works?()
During the diesel engine running, the water level of F.W expansion tank should normally kept in the () level of glass tube.
The additional mark ()in the Classification Certificate for Machinery means propulsion apparatus is remotely controlled on the navigating bridge control station, and engine assembly control station is unmanned periodically.
The condensers located in various stages of a flash evaporator are cooled by()
To proceed to the assistance of a ship in distress is()
Using a file without a handle may result in ()
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?()
The ISPS Code consists of a mandatory section-Part A, which shows()
The main purpose of port State control is not to()
() is not installed on the main switchboar.