A.rolling member size
B.inner race cone width
C.manufacturers numerical code
D.outer ring width
您可能感興趣的試卷
你可能感興趣的試題
A.mechanical energy to kinetic energy to potential energy
B.mechanical energy to potential energy to kinetic energy
C.potential energy to mechanical energy to kinetic energy
D.kinetic energy to mechanical energy to potential energy
A.The wearing rings are excessively worn
B.The suction strainer is clogged
C.The discharge valve is clogged
D.The shaft is worn
A.sudden evaporation of wax crystals in the lubricant
B.sudden evaporation of entrapped air in the lubricant
C.release of refrigerant from the oil/refrigerant mixture
D.release of dissolved lubricant from the refrigerant
A.motor overload will open
B.relief valve will open
C.pump will overheat
D.motor will overheat
A.The liquid receiver functions to collect and remove non-condensable gases
B.A thermostatic expansion valve is used to control refrigerated space temperature
C.Refrigerant temperature in an evaporator is directly related to refrigerant pressure
D.Dehydrators must be used continuously in a refrigeration system
最新試題
Which of the following statements is correct concerning heat transfer?（）
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
On tank vessels equipped with power operated cargo tank valves, the type of power operator most commonly used is （）.
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by （）.
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）